I was trying to determine what type of connector the p5055m-ext-us uses. I see you have an antenna on the Trango web store, but I was wanting to shop around a little bit too just for comparison sake. Could you please advise what type of connector this is?
Articles in this section
- TL45 Keeps Resetting the TX power to xxxx dBm
- No Management, but Passing Traffic
- TrangoLink45 Link Budget Calculator
- Lightning Protection
- Power problems on trangolink 45
- Whats a good signal strength?
- Connector on p5055m-ext-us
- How to change TL45 read and write community string?
- Trango45 VLAN support
- Monitor Bandwidth Usage
Whoops, sorry about that, I found the info after sending that. It's an 'RP‐SMA.'
This is our first connectorized T-Link or EXT model, does the polarity now depend solely on the antenna, or do will any 5Ghz, RP-SMA antenna allow me to software-switch between H and V pol? Thanks.
There is a V and a H output on the unit. As long as you connect both to a dual polarity antenna, you can software switch. If you only connect one polarity, then only that one will work. Note that you should look at the labeling and make sure you connect the V RP-SMA to the V position on the dual pol antenna.
It is not required to connect both if you have a reason for only connecting one polarity (like having two units on the same path).
Please sign in to leave a comment.